Workshop Manuals Factory service & repair Rover
Rover 200 Workshop Manual (1995-1999)20 · Automatic gearbox
20 · Transmission

Primary bearing (page 4 of 4)

Make
Rover
Model
200 Workshop Manual
Year
1995–1999
Section
Repairs
Automatic gearboxPrimary bearing · page 4 of 4
  1. Lubricate and fit new ’O’ rings to oil pump.
  2. Position oil pump into gearbox, aligning feeder and pitot tube channels.
  3. Fit 5 bolts and tighten in a diagonal sequence to 10 Nm.
  4. Lubricate and fit new primary cover ’O’ ring to gearbox housing.
  5. Position pitot tube in oil pump, fit pitot chamber ensuring pitot tube is located in oil pick-up channel in pitot chamber.
  6. Rotate pitot chamber sufficient to align pitot tube, fit remaining oil pump bolt and tighten to 10 Nm.
  7. Align pitot chamber to oil pump drive, fit new bolts and tighten to 10 Nm.
  8. Fit primary cover. See this section.
  9. Raise engine/gearbox with hoist to align lH gearbox mounting to bracket.
  10. Fit special washer and nut, tighten nut.
  11. Release hoist from lifting bracket.
  12. Remove lifting bracket from cylinder head.
  13. Clean camshaft rear cover plate and mating face.
  14. Fit camshaft cover plate and tighten bolts to 10 Nm.
  15. Position battery tray and tighten 3 bolts securing battery tray to body to 10 Nm.
  16. Position engine compartment fuse box to body, fit and tighten bolt to 10 Nm.
  17. Fit 4 bolts securing battery tray to body and tighten to 10 Nm.
  18. Fit and tighten bolt securing engine compartment fuse box to battery tray.
  19. Position relay module and ABS fuse holder to battery tray.
  20. Position engine management ECM to battery tray and tighten bolts to 10 Nm.
  21. Fit air cleaner. See ENGINE MANAGEMENT SYSTEM - MEMS, Repairs.

Parts & tools for this job For 1995 Rover 200

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.