Catalytic converter heat shield - ’K8’ and ’K16’ (page 2 of 2)
- Make
- Rover
- Model
- 200 Workshop Manual
- Year
- 1995–1999
- Section
- Repairs
Emission controlCatalytic converter heat shield - ’K8’ and ’K16’ · page 2 of 2
Refit
- Fit catalytic converter heat shield.
- Fit bolts securing heat shield to transmission tunnel and tighten to 6 Nm.
- Connect selector rod to shaft and align holes.
- Fit new roll pin securing selector rod to shaft and fit roll pin retaining clip.
- Fit washers to gear change steady bar and connect to gearbox.
- Fit bolt securing gear change steady bar to gearbox and tighten to 10 Nm.
- Lower vehicle.
Parts & tools for this job For 1995 Rover 200
- PARTExhaust gasketSearch: Rover 200 1995 exhaust gasket
- TOOLPenetrating oilSearch: penetrating oil
- TOOLOBD2 scannerSearch: OBD2 scanner
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.