Electronic diesel control operation (Engine management system - EDC) (page 2 of 2)
- Make
- Rover
- Model
- 400 Workshop Manual
- Year
- 1995–2000
- Section
- Description and operation
Engine management system - EDCElectronic diesel control operation · page 2 of 2
The ECU inputs and outputs are shown in the following table.
| INPUTS Crankshaft sensor Manifold absolute pressure* Coolant temperature sensor Intake air temperature sensor* Fuel temperature sensor Mass air flow sensor Injector needle lift sensor Vehicle speed sensor Fuel quantity servo - position Throttle position sensor* Brake pedal switch* Diagnostic input Battery supply Starter signal Earth supply |
| ECM |
*Models with intercooler (Bosch ECM) fitted
| OUTPUTS Glow plug relay EGR modulator valve Fuel shut off solenoid Glow plug lamp Engine warning lamp Diagnostic connector Injection timing device Fuel quantity servo - control actuator |
Parts & tools for this job For 1995 Rover 400
- PARTGlow plugsSearch: Rover 400 1995 glow plugs
- TOOLGlow plug socketSearch: glow plug socket
- TOOLDiesel compression testerSearch: diesel compression tester
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.