Leon Mk2
| Assembly chart |
Note!| t | Disconnect the negative terminal of the battery. |
| t | In vehicles fitted with coded radio, first consult the anti-theft code. |
| t | Lubricate all bearings and contact surfaces with lubricating grease -G 052 142 A2-. |
| t | Before working on the pedals, dismount the map compartment on the driver's side → Body - interior assembly work; Rep. Gr.70. |
| 1 - | Mounting |
| q | Dismount the steering column to take the mounting off → Drive train; Rep. Gr.48 |
| q | Remove the brake pedal from the main brake cylinder → Brake system; Rep. Gr.47 |
| 2 - | Hexagonal screw, 25 Nm |
| 3 - | Self-locking hexagonal nut, 25 Nm |
| q | 5 in all |
| q | For securing the mounting to the power-assisted brake system |
| 4 - | Support |
| 5 - | Hexagonal screw, 25 Nm |
| 6 - | Lock |
| q | Dismounting and assembly → Chapter |
| 7 - | Clutch and brake pedal axle |
| q | Assembly position: the bracket -arrow- must face the side of the clutch pedal |
| 8 - | Bearing sleeve |
| q | For housing the steering column |
| 9 - | Brake pedal |
| 10 - | Saddle |
| 11 - | Clutch pedal |
| q | Dismounting and assembly → Chapter |
| 12 - | Lock |
| q | Dismounting and assembly → Chapter |
| 13 - | Bracket |
| q | For the clutch cable |
| 14 - | Clamp |
| q | This secures the bracket to the compensation box |
| 15 - | Clutch cable |
| q | Automatic reset |
| q | Assign according to the Replacement Parts Microfiche |
| q | Checking its operation |
| q | Dismounting and assembly → Chapter |
| 16 - | Clutch cable |
| q | Non-automatic reset |
| q | Assign according to the Replacement Parts Microfiche |
| q | Dismounting and assembly → Chapter |
| q | Adjusting → Chapter |
| 17 - | Adjusting nut for the clutch cable |
| q | Tighten the lock nut after having made the adjustment |
| 18 - | Return spring |
| q | This should not be attached if an automatic clutch cable is fitted |
| 19 - | Hood |
| q | This fits into the dashboard |