Leon Mk2
| Assembly overview: Pedal cluster |
| 1 - | Bulkhead |
| q | With support for mounting bracket and master cylinder |
| 2 - | Seal |
| q | Availability → Electronic parts catalogue (ETKA) |
| q | Stick to master cylinder |
| 3 - | Circulation hose |
| q | replace → Item |
| 4 - | Mounting |
| q | Availability → Electronic parts catalogue (ETKA) |
| q | fit into mounting bracket → Fig. Installing extension spring |
| q | No specific installation position needs to be adhered to. |
| 5 - | Clutch position sender -G476- |
| q | Availability → Electronic parts catalogue (ETKA) |
| q | For vehicles with start stop system |
| q | Allocate components using → Electronic parts catalogue (ETKA) |
| q | Removing and installing → Chapter>>>>>>>> |
| q | Can be checked in „Guided fault finding“, using vehicle diagnostic, testing and information system → Electrical system, general information; Rep. gr.97 |
| 6 - | Extension spring |
| q | Availability → Electronic parts catalogue (ETKA) |
| q | Hooked into mounting bracket and into clutch pedal |
| q | Removing → Fig. |
| q | Installing → Fig. |
| 7 - | Drift sleeve |
| q | Availability → Electronic parts catalogue (ETKA) |
| q | Chamfer -arrow- faces master cylinder. |
| q | Press in flush. |
| 8 - | Bolt, 13 Nm |
| 9 - | Mounting bracket with clutch pedal |
| q | Availability → Electronic parts catalogue (ETKA) |
| q | Removing and installing with master cylinder → Chapter |
| q | Removing and installing without master cylinder → Chapter |
| 10 - | Bolt, 20 Nm |
| 11 - | Crash bar |
| q | Availability → Electronic parts catalogue (ETKA) |
| q | Attached to steering column |
| q | Allocate components using → Electronic parts catalogue (ETKA) |
| 12 - | Checking clutch pedal switch -F36- |
| q | Removing and installing → Chapter>>>>>>>> |
| 13 - | Bearing shaft |
| q | Availability → Electronic parts catalogue (ETKA) |
| q | For plunger/master cylinder |
| q | Always replace. |
| 14 - | Cap |
| 15 - | Stop |
| q | Availability → Electronic parts catalogue (ETKA) |
| q | For clutch pedal |
| 16 - | Self-locking hexagon nut, 25 Nm |
| q | 3 units |
| q | Always replace. |
| 17 - | Mounting bush |
| q | Availability → Electronic parts catalogue (ETKA) |
| q | Removing → Fig. |
| q | Installing → Fig. |
| 18 - | Master cylinder |
| q | Removing and installing → Chapter>>>>>>>> |
| 19 - | Clip |
| q | To remove and install pipe, pull out clip as far as it will go |
|
|