Workshop Manuals Factory service & repair SEAT
01 Power transmission02 Running gear03 Body04 Power tramsmission05 Power unit06 Vehicle electrics07 Heating-ventilation-air conditioning system08 Automatic gearbox09 Engine, mixture preparation10 Engine, mechanics11 Manual gearbox12 Running gear - self diagnosis13 Heating and air conditioning14 Bodywork15 Heating, ventilation, air conditioning system
SEAT Leon Mk202 · Running gear
02 · Steering & suspension

Adjusting parking brake

Make
SEAT
Model
Leon Mk2
Section
Brake, brake mechanics › Handbrake › Adjusting parking brake
Running gearAdjusting parking brake
Adjusting parking brake
A new adjustment is only necessary when the brake cables, brake carrier or brake pads are renewed.
–  Remove centre console → General body repairs, interior; Rep. gr.68.
–  The foot brake must be functional and bled.
l  Parking brake lever is in normal position (released).
–  Loosen brake cables by means of adjustment nut -arrow A-.
–  Firmly depress brake pedal three times.
–  Pretension brake cable with adjustment nut -arrow A- just until parking brake lever returns to normal position on its own (see note below).
Adjusting parking brake – SEAT Leon Mk2  Note
Pull parking brake lever from normal position to right before it engages in first tooth. Release handbrake lever. The lever must return to the support automatically.
–  Pull handbrake lever on 4 notches.
   
–  Tighten adjustment nut -arrow A- until both wheels cannot be turned by hand.
Adjustment nut -arrow A- must be screwed over end of pull rod -1-.
–  Release parking brake and check that both wheels turn freely. If required turn adjustment nuts back slightly.
–  Install centre console → General body repairs, interior; Rep. gr.68.
Due to the automatic rear wheel brake adjustment, there is no requirement to adjust the parking brake after making new/initial adjustment.
  N46-0326

Parts & tools for this job For SEAT Leon

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.