Removing and installing steering lock

Make

Skoda

Model

Fabia Mk2

Section

Chassis › Steering › Removing and installing steering lock

Running gearRemoving and installing steering lock

Removing and installing steering lock Special tools and workshop equipment required t  Vehicle diagnosis, measurement and information system -VAS-   Note Pay attention to the measures after re-connecting the battery → Electrical System; Rep. gr.27. Remove steering lock: –  Disconnect battery → Electrical System; Rep. gr.27. –  Remove steering wheel with airbag → Body Work; Rep. gr.69. –  Remove dash panel protective label with top steering column trim panel → Body Work; Rep. gr.69. –  Remove bottom steering column trim panel → Body work; Rep. gr.69. –  Removing steering-column control → Electrical System; Rep. gr.94.

–  Unplug connector for the ignition starter switch -1- and the connector for the immobilizer -2- reading coil. –  Removing lock cylinder and ignition starter switch → Electrical System; Rep. gr.94.

–  Remove pull-off screws -arrows- (bore out). –  Take out steering lock.

Install steering lock: –  Insert the steering lock and tighten with new pull-off screws. –  Tighten pull-off screws until the screw head shears off. –  Installing lock cylinder and ignition starter switch → Electrical System; Rep. gr.94. –  Unplug connector for the ignition starter switch -1- and connect the connector for the immobilizer -2- reading coil. –  Install the steering-column control → Electrical System; Rep. gr.94. –  Install bottom steering column trim panel → Body Work; Rep. gr.70. –  Install dash panel protective label with top steering column trim panel → Body Work; Rep. gr.70. –  Install the steering wheel with airbag → Body Work; Rep. gr.69.   Note Pay attention to the measures after re-connecting the battery → Electrical System; Rep. gr.27. –  Connect battery → Electrical System; Rep. gr.27. –  Interrogate fault memory or eliminate fault → Vehicle diagnostic tester.

01 Steering & suspension