Octavia Mk1
Note
|
1 - | Heat shield |
2 - | Nut, 23 Nm |
3 - | 23 Nm |
4 - | Pressure line (expansion hose) |
t | from the vane pump to the power-steering gear |
5 - | Gasket rings |
t | replace after each removal |
6 - | Hollow screw, 38 Nm |
t | M14 x 1.5 |
7 - | Nut, 23 Nm |
8 - | Clamp with rubber insert |
Fitting position: |
t | Arrow on the clamp points in the direction of travel |
t | replace the clamp if the thread of the weld nut is damaged |
9 - | Power-steering gear |
t | adjust → Chapter |
t | removing and installing → Chapter |
10 - | Assembly carrier |
11 - | 20 Nm + 90° |
t | replace after each removal |
12 - | 20 Nm + 90° |
t | replace after each removal |
13 - | 20 Nm + 90° |
t | replace after each removal |
14 - | 40 Nm + 90° |
t | replace after each removal |
15 - | Pendulum support |
16 - | 20 Nm + 90° |
t | replace after each removal |
17 - | 100 Nm + 90° |
t | replace after each removal |
18 - | 100 Nm + 90° |
t | replace after each removal |
19 - | Self-locking nut, 50 Nm |
t | replace after each removal |
20 - | Steering-knuckle arm of the wheel-bearing housing |
21 - | Counternut, 50 Nm |
22 - | Pressure line |
23 - | Hollow screw, 38 Nm |
t | M14 x 1.5 |
24 - | Hollow screw, 45 Nm |
t | M16 x 1.5 |
25 - | Gasket rings |
t | replace after each removal |
26 - | Return-flow line |
t | from the power-steering gear to the reservoir for central hydraulic oil |
27 - | Sealing sleeve |
t | Pay attention to installation instructions → Chapter |
28 - | 20 Nm + 90° |
t | replace after each removal |
29 - | Steering column universal joint |