Handbrake lever - Summary of components

Make

Skoda

Model

Yeti

Section

Brake systems › Brake, brake mechanics › Handbrake lever - Summary of components

Running gearHandbrake lever - Summary of components

Removing and installing the hand-brake cable Removing: –  Put hand-brake back. –  Remove the centre console → Body Work; Rep. gr.68.

–  Release the adjusting nut -1- so far until the respective hand-brake cable -2- can be unhooked from the compensating clamp -3-.

–  Press the lever -2- in the -direction of the arrow- and while doing so unhook the hand-brake cable -3-. –  Slacken the spring bushing -1- for the hand-brake cable from the bracket on the brake caliper.

–  Slacken the hand-brake cable from the bracket -3- at the trailing arm and pull the cable out of the bracket. –  Unhook the hand-brake cable from the attachment holder and pull out of the guide tube. Installing: –  Push the hand-brake cable into the guide tube and attach it to the bracket.

–  Pull the hand-brake cable through the bracket -3- and through the bracket on the brake caliper.

–  Clip the spring bushing -1- into the bracket on the brake caliper.

–  Clip the hand-brake cable into the bracket -3- on the trailing arm.

–  Press the lever -2- in the -direction of the arrow- and hook the hand-brake cable -3- into the lever.

–  Hook the hand-brake cable -2- into the compensating clamp -3-. –  Tension the hand-brake cable with the adjusting nut -1-. –  Setting the hand-brake → Chapter.

01 Steering & suspension