7.INSPECT CRANKSHAFT THRUST CLEARANCE - Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
- Make
- Toyota
- Model
- Hilux Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
- Section
- DISASSEMBLY › 7.INSPECT CRANKSHAFT THRUST CLEARANCE - Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
7.INSPECT CRANKSHAFT THRUST CLEARANCE
CAUTION: Be sure to wear protective gloves.
c. Using a plastic-faced hammer and brass bar, lightly tap out the piston pin from the piston. Then remove the connecting rod sub-assembly.
HINT:
· The piston and piston pin are a matched set.
· Be sure to organize the removed pistons, piston pins, piston rings, connecting rod sub-assemblies and connecting rod bearings in such a way that the parts can be reinstalled exactly as before.
· Arrange the pistons, piston pins, connecting rod sub-assemblies and connecting rod bearings in the correct order.
7.INSPECT CRANKSHAFT THRUST CLEARANCE
a.

Using a dial indicator, measure the crankshaft thrust clearance while prying the crankshaft back and forth with a screwdriver. Standard thrust clearance:
0.04 to 0.24 mm (0.00157 to 0.00945 in.) Maximum thrust clearance:
0.24 mm (0.00945 in.) If the thrust clearance is more than the maximum, replace the upper crankshaft thrust washers and lower crankshaft thrust washers. If necessary, replace the crankshaft. Standard crankshaft thrust washer thickness:
2.2 to 2.8 mm (0.0866 to 0.110 in.)
13411
8.REMOVE CRANKSHAFT
a.

Parts & tools for this job For Toyota Hilux
- PARTEngine gasket setSearch: Toyota Hilux engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
As an Amazon Associate we earn from qualifying purchases.