/ ACTIVE TEST - Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
- Make
- Toyota
- Model
- Hilux Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
- Section
- REGISTRATION › / ACTIVE TEST - Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
/ ACTIVE TEST

h. Confirm the condition of the engine and wait until learning can be performed. Essential Conditions for Learning
| GTS Display | Standard |
|---|---|
| Coolant Temp | 70 to 100°C |
| Intake Air | -25 to 120°C |
| Battery Voltage | 10 V or higher |
| Pilot Quantity State(CAT) | READY |
| Atmosphere Pressure | 70 kPa or higher |
HINT:
· If the values deviate from the standard above, "Pilot Quantity Learning" enters a standby state or is canceled.
· When the display indicates that "Pilot Quantity State(CAT)" is NG, perform "Pilot Quantity Learning" after performing the "Activate the DPF Rejuvenate (PM)" Active Test using the GTS.
/ ACTIVE TEST
· When the essential conditions to perform learning are met, the screen will change automatically.
NOTICE:
· If "Activate the DPF Rejuvenate (PM)" is performed after an injector compensation code is input but before "Pilot Quantity Learning" is performed, DTC P062F is stored and the MIL illuminates due to "Pilot Quantity Learning" being incomplete.
· Using the GTS, make sure that DTCs other than DTC P062F are not output.
· If DTCs other than DTC P062F are output, perform troubleshooting for those DTCs, and then perform "Activate the DPF Rejuvenate (PM)".
HINT: DTC P062F is stored when the value registered in the ECM for an input injector compensation code, catalyst deterioration learning value and/or pilot quantity deterioration learning value is the initial value.
i.

*a Example
Parts & tools for this job For Toyota Hilux
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Toyota Hilux
As an Amazon Associate we earn from qualifying purchases.