9.INSPECT 3RD GEAR THRUST WASHER - Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
- Make
- Toyota
- Model
- Hilux Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
- Section
- INSPECTION › 9.INSPECT 3RD GEAR THRUST WASHER - Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
‹ Prev 8.INSPECT NO. 3 SYNCHRONIZER RING SET - Toyota Hilux AN120/AN130 2015-2018 Workshop ManualNext › INPUT SHAFT - REASSEMBLY: RC60F / RC61F MANUAL TRANSMISSION / - Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
INPUT SHAFT9.INSPECT 3RD GEAR THRUST WASHER - Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
9.INSPECT 3RD GEAR THRUST WASHER
i. Turn the synchronizer ring in both directions while pushing it against the 3rd gear cone. Check that the ring locks in both directions. If the No. 3 synchronizer ring set turns, replace it.
33342C
9.INSPECT 3RD GEAR THRUST WASHER
a.

Using a micrometer, measure the 3rd gear thrust washer thickness. Standard thickness:
7.62 to 7.68 mm (0.3000 to 0.3023 in.) Minimum thickness:
7.62 mm (0.3000 in.) If the thickness is less than the minimum, replace the 3rd gear thrust washer.
‹ Prev 8.INSPECT NO. 3 SYNCHRONIZER RING SET - Toyota Hilux AN120/AN130 2015-2018 Workshop ManualNext › INPUT SHAFT - REASSEMBLY: RC60F / RC61F MANUAL TRANSMISSION / - Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
Parts & tools for this job For Toyota Hilux
As an Amazon Associate we earn from qualifying purchases.