Workshop Manuals Factory service & repair Toyota
01 Toyota Land Cruiser J7002 Toyota Land Cruiser J70 - General
Toyota Toyota Land Cruiser J70 Workshop Manual01 · Toyota Land Cruiser J70
01 · Electrical

IF NECESSARY, CHARGE SYSTEM - Toyota Land Cruiser J70 Workshop Manual

Make
Toyota
Model
Land Cruiser Toyota Land Cruiser J70 Workshop Manual
Section
Air Conditioning › IF NECESSARY, CHARGE SYSTEM - Toyota Land Cruiser J70 Workshop Manual
Toyota Land Cruiser J70IF NECESSARY, CHARGE SYSTEM - Toyota Land Cruiser J70 Workshop Manual

IF NECESSARY, CHARGE SYSTEM

1984 LJ70 RJ70 Repair Manual 38261E: diagram
1984 LJ70 RJ70 Repair Manual 38261E: diagram

AIR CONDITIONING SYSTEM — Refrigeration System

6.

IF NECESSARY, CHARGE SYSTEM WITH

ANOTHER REFRIGERANT CONTAINER

Close (a) When the refrigerant container is empty, close the Loosen Slightly pressure valves. (b) Remove the container tap valve from the container. (c) Attach the container tap valve to a new refrigerant container. Air DFE Air (d) Purge the air from the center hose by slightly opening the low pressure valve and loosening the valve disc. = (e)

Make a hole in the sealed tap of the new container

and charge the system.

CAUTION: Be careful not to overcharge the refrigerant as it could cause failure of the bearings and belt. |

7.

WHEN SYSTEM IS FULLY CHARGED, DISCONNECT

MANIFOLD GAUGE SET

| (a) Close both low and high pressure valves. (b) Close the valve of the refrigerant container. one-pound containers of R-12, allow remaining q refrigerant to escape by slowly removing the charge line. | (c) Turn off the engine. | (d) Using a shop rag, quickly remove both hoses from the compressor service valves.

WARNING: Care must be taken to protect eyes and skin when removing the high pressure hoses. | (e) Put the cap nuts on the service valve fittings.

|

Performance Test

1,

INSTALL MANIFOLD GAUGE SET

(a) Close the high pressure and low pressure hand valves. (b) Connect the high pressure hose to the discharge ser- vice valve of the compressor. (c) Connect the low pressure hose to the suction service v valve of the compressor.

Dry-bulb Thermometer

2.

RUN ENGINE AND OPERATE AIR CONDITIONER

(a) Run the engine at 2,000 rpm. (b) Set the blower switch at HI, temperature control switch ON, temperature control at COOL, and air = = flow control at VENT. 7 (c) Keep all windows and doors open. |

3.

POSITION THERMOMETERS

Psychrometer | (a)

Place a dry-bulb thermometer in the cool air outlet.

~ (b)

Place a psychrometer close to the inlet of the cooling

SS unit.

Donated by Onur Azeri . cruisercult.com

Parts & tools for this job For Toyota Land Cruiser

As an Amazon Associate we earn from qualifying purchases.