Workshop Manuals Factory service & repair Toyota
01 Toyota Land Cruiser J7002 Toyota Land Cruiser J70 - General
Toyota Toyota Land Cruiser J70 Workshop Manual01 · Toyota Land Cruiser J70
01 · Electrical

REFRIGERATION SYSTEM - Toyota Land Cruiser J70 Workshop Manual

Make
Toyota
Model
Land Cruiser Toyota Land Cruiser J70 Workshop Manual
Section
Air Conditioning › REFRIGERATION SYSTEM - Toyota Land Cruiser J70 Workshop Manual
Toyota Land Cruiser J70REFRIGERATION SYSTEM - Toyota Land Cruiser J70 Workshop Manual

REFRIGERATION SYSTEM

1984 LJ70 RJ70 Repair Manual 38261E: diagram
1984 LJ70 RJ70 Repair Manual 38261E: diagram

AIR CONDITIONING SYSTEM — Refrigeration System

REFRIGERATION SYSTEM

Checking of Refrigerant Charge

I “y -

1.

RUN ENGINE AT FAST IDLE

. af, “ } a V/

H 7)

2.

OPERATE AIR CONDITIONER AT MAXIMUM

COOLING FOR A FEW MINUTES

Saat Glee

| 3,

CHECK AMOUNT OF REFRIGERANT

Observe the sight glass on the receiver. = ke Item Symptom Amount of refrigerant Remedy ere __ = ST Pe 1 | Bubbles present in sight glass _Insufficient ee _ Check for leak with gas leak tester 2

| No bubbles present in sight glass

None, sufficient or too much

Refer to items 3 and 4

3 “T No temperature difference between

Empty or nearly empty | Evacuate and charge system. Then check for leak with gas leak tester

[ter between compressor

compressor inlet and outlet Proper or too much © [Refer to items 5 and6 4 inlet and outlet is noticeably | different

| Discharge excess refrigerant to

5 | Immediately after air conditioner Too much is turned off, refrigerant in sight specified amount glass stays clear When air conditioner is turned off, Proper | 6 refrigerant foams and then stays clear —

Installation of Manifold Gauge Set

To Refrigeration

NOTE: Fittings for attaching the manifold gauge set are Charging Hose System located on the compressor service valves. coe

1.

CLOSE BOTH HAND VALVES OF MANIFOLD

To Manifold ~~

GAUGE SET

:

Gauge To Compressor

2.

INSTALL CHARGING HOSES OF GAUGE SET TO

SERVICE VALVES

Connect the low pressure hose to the suction service valve and the high pressure hose to the discharge service valve. Tighten the hose nuts by hand.

NOTE: Do not apply compressor oil to the seat of the connection.

Donated by Onur Azeri . cruisercult.com

Parts & tools for this job For Toyota Land Cruiser

As an Amazon Associate we earn from qualifying purchases.