PRESSURE SWITCH - Toyota Land Cruiser J70 Workshop Manual
- Make
- Toyota
- Model
- Land Cruiser Toyota Land Cruiser J70 Workshop Manual
- Section
- Air Conditioning › PRESSURE SWITCH - Toyota Land Cruiser J70 Workshop Manual
PRESSURE SWITCH

AC-30 AIR CONDITIONING SYSTEM — Pressure Switch, Vacuum Switching Valve (VSV)


PRESSURE SWITCH
(See page AC-18)
INSPECTION OF PRESSURE SWITCH
1.
CHECK REFRIGERANT PRESSURE
(a) Connect the hoses of the manifold gauge set to the compressor service valves and observe the gauge reading. (b) The gauge reading must be more than 2.1 kg/cm? (30 psi, 206 kPa) when the ambient temperature is higher than 0°C (32°F). If the pressure is less than 2.1 kg/cm? (30 psi, 206 kPa), charge the refrigerant. (See page AC-12)

2.
CHECK PRESSURE SWITCH
(a) Remove the glove box. ° Disconnect the lead wires of the A/C harness. (b) | Pressure Switch — Connector (c) Using an ohmmeter, check the continuity between — the two terminals of the pressure switch. ‘Aco469 The ohmmeter must indicate zero ohm. \f there is no continuity, replace the pressure switch. (See page AC-18)
3.
REINSTALL REMOVED PARTS IN REVERSE
ORDER
VACUUM SWITCHING VALVE (VSV)
(See page AC-18)
INSPECTION OF VSV
1.
DISCONNECT VACUUM HOSES AND CONNECTOR
FROM VSV
2.
CHECK VACUUM CIRCUIT CONTINUITY IN VSV
BY BLOWING AIR INTO PIPE
(a) Connect the VSV terminals to the battery terminals as shown. (b) Blow into pipe ‘A’, and check that air comes out of vs Battery pipe “B.”” ® (2) | — Aco18?
Donated by Onur Azeri . cruisercult.com
Parts & tools for this job For Toyota Land Cruiser
- TOOLOBD2 scannerSearch: OBD2 scanner
- TOOLDigital multimeterSearch: automotive digital multimeter
- TOOLBack-probe test leadsSearch: back probe test leads
As an Amazon Associate we earn from qualifying purchases.