DTC C0558
Diagnostic Instructions
DTC Descriptors
DTC C0558 55: Calibration Data Too Few
Transitions |
DTC C0558 5A: Calibration Data Not
Plausible |
Circuit/System Description
The parking brake control module has an internal motor, apply
actuator, release actuator, and temperature sensor. The parking
brake control module also contains the logic for applying and
releasing the parking brake when commanded by the park brake
control switch. When the parking brake control module receives a
signal from the switch the internal circuit board temperature is
checked to verify it is within operating range before the control
module performs the requested operation.
Conditions for Running the DTC
Ignition OFF, ACCESSORY, or RUN mode.
Conditions for Setting the DTC
C0558 55
The parking brake control module detects a calibration malfunction.
C0558 5A
The parking brake control module detects mechanical problems with
the parking brake system.
Action Taken When the DTC Sets
C0558 55
• |
The electric parking brake is
disabled, switch command will not be accepted. |
• |
A message and/or a warning
indicator may be displayed. |
C0558 5A
• |
The electric parking brake is
disabled, one release allowed. |
• |
A message and/or a warning
indicator may be displayed. |
Conditions for Clearing the DTC
• |
The parking brake control
module clears the history DTC when a current DTC is not detected in
40 ignition cycles. |
• |
Calibrate the parking brake
control module. |
Diagnostic Aids
• |
Verify the parking brake
control module software and calibrations are the newest available
versions. |
• |
Verify the parking brake cable
is not broken or pinched. |
Reference Information
Schematic Reference
Park Brake System Schematics
Connector End View Reference
Component Connector End Views
Description and Operation
Electronic Parking Brake Control Module Description
Electrical Information Reference
Scan Tool Reference
Control Module References for scan tool information
Circuit/System Verification
1. |
Ignition ON, command the Park
Brake Cable Service Apply ON with a scan tool. Verify the Park
Brake Cable Position parameter is below 1250 counts. |
⇒ |
If greater than the specified value, make sure the
park brake cable is connected properly and check park brake linings
for excessive wear, and ensure proper clearance to drum. |
2. |
Verify DTC C0558 is not
set. |
⇒ |
If DTC is set, perform the Park Brake Calibration
procedure in Configuration/Reset Functions. |
Repair Instructions
Perform the
Diagnostic Repair Verification after completing the diagnostic
procedure.
Control Module References for parking brake control module
replacement, setup, and programming
|