Workshop Manuals Factory service & repair Vauxhall
01 Preface02 General Information03 Body Hardware and Trim04 Body Repair05 Body Systems06 General Vehicle Information07 Brakes08 Diagnostic Navigation09 Driveline/Axle10 Driver Information and Entertainment11 Engine12 HVAC13 Power and Signal Distribution14 Roof15 Safety and Security16 Seats17 Steering18 Suspension19 Transmission/Transaxle
Vauxhall Astra J07 · Brakes
07 · Brakes

DTC C056D

Make
Vauxhall
Model
Astra J
Section
Diagnostic Information and Procedures › Miscellaneous › DTC C056D
BrakesDTC C056D

DTC C056D

Diagnostic Instructions

•  Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
•  Review Strategy Based Diagnosis for an overview of the diagnostic approach.
•  Diagnostic Procedure Instructions provide an overview of each diagnostic category.

DTC Descriptors

DTC C056D 34: ECU Hardware Performance RAM Failure
DTC C056D 35: ECU Hardware Performance ROM Failure
DTC C056D 36: ECU Hardware Performance EEPROM Failure
DTC C056D 37: ECU Hardware Performance Watchdog/Safety uC Failure
DTC C056D 39: ECU Hardware Performance Internal Electronic Failure
DTC C056D 3C: ECU Hardware Performance Internal Communications Failure

Circuit/System Description

The parking brake control module has an internal motor, apply actuator, release actuator, and temperature sensor. The parking brake control module also contains the logic for applying and releasing the parking brake when commanded by the park brake control switch. When the parking brake control module receives a signal from the switch the internal circuit board temperature is checked to verify it is within operating range before the control module performs the requested operation. The parking brake module will perform diagnostics on the modules internal hardware to verify it is functioning properly

Conditions for Running the DTC

Ignition OFF, ACCESSORY, or RUN mode.

Conditions for Setting the DTC

The parking brake control module detects an internal hardware malfunction.

Action Taken When the DTC Sets

•  The electric parking brake is disabled.
•  A message and/or a warning indicator may be displayed.

Conditions for Clearing the DTC

•  The parking brake control module clears the history DTC when a current DTC is not detected in 40 ignition cycles.
•  The condition for the DTC is no longer present.
•  The latest software and calibrations are programmed into the parking brake control module.

Reference Information


Schematic Reference

Park Brake System Schematics


Connector End View Reference

Component Connector End Views


Description and Operation

Electronic Parking Brake Control Module Description


Electrical Information Reference


Scan Tool Reference

Control Module References for scan tool information

Circuit/System Verification

1. Verify DTC C056D 36 is not set.
2. With a scan tool , perform the Parking Brake Actuator DTC Reset procedure. Verify DTC C056D is not set.
⇒ If the DTC is set, replace the K83 Parking Brake Control Module.

Repair Instructions

Perform the Diagnostic Repair Verification

Parts & tools for this job For Vauxhall Astra

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.