Workshop Manuals Factory service & repair Vauxhall
Vauxhall Astra J08 · Diagnostic Navigation
08 · Diagnostics

Instrument Cluster Programming and Setup

Make
Vauxhall
Model
Astra J
Section
Programming and Setup › Repair Instructions › Instrument Cluster Programming and Setup
Diagnostic NavigationInstrument Cluster Programming and Setup

Instrument Cluster Programming and Setup

The following service procedures require either a programming or a setup event performed for a complete repair.

Instrument Cluster Replacement

If the instrument cluster needs to be replaced, the following procedures must be performed:

1. Connect a scan tool to the vehicle and access SPS. Refer to Service Programming System (SPS) .
2. Perform the SPS function Instrument Cluster - Programming and follow the on-screen instructions.
3. Perform the SPS function Instrument Cluster - Configuration & Setup and follow the on-screen instructions. On the screen Control Module - Configuration and Setup Function(s), select both ECU Configuration/Reconfiguration and ECU Setup.
4. Clear DTCs after completing the programming procedure.

Instrument Cluster Reprogramming

Do not reprogram the instrument cluster, unless directed by a service procedure, or a service bulletin.

1. Connect a scan tool to the vehicle and access SPS. Refer to Service Programming System (SPS) .
2. Perform the SPS function Instrument Cluster - Programming and follow the on-screen instructions.
3. Clear DTCs after completing the programming procedure.

Parts & tools for this job For Vauxhall Astra

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.