Workshop Manuals Factory service & repair Vauxhall
01 Preface02 General Information03 Body Hardware and Trim04 Body Repair05 Body Systems06 General Vehicle Information07 Brakes08 Diagnostic Navigation09 Driveline/Axle10 Driver Information and Entertainment11 Engine12 HVAC13 Power and Signal Distribution14 Roof15 Safety and Security16 Seats17 Steering18 Suspension19 Transmission/Transaxle
Vauxhall Astra J15 · Safety and Security
15 · General

DTC B3105

Make
Vauxhall
Model
Astra J
Section
Remote Functions › Other Information › DTC B3105
Safety and SecurityDTC B3105

DTC B3105

Diagnostic Instructions

    •  Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
    •  Review Strategy Based Diagnosis for an overview of the diagnostic approach.
    •  Diagnostic Procedure Instructions provides an overview of each diagnostic category.

DTC Descriptor

DTC B3105 00:  Keyless Entry System Key Fobs

Circuit/System Description

The body control module (BCM) monitors the number of keyless entry transmitters programmed. Until at least one transmitter is programmed, the BCM determines a malfunction condition exists.

Conditions for Running the DTC

The BCM has been set up without transmitters being programmed.

Conditions for Setting the DTC

No keyless entry transmitter programmed to the BCM.

Action Taken When the DTC Sets

The keyless entry system is inoperative.

Conditions for Clearing the DTC

A current DTC is cleared when at least one transmitter has been programmed to the BCM.

Reference Information

Schematic Reference

Remote Function Schematics

Connector End View Reference

Component Connector End Views

Description and Operation

Keyless Entry System Description and Operation

Electrical Information Reference

    •  Circuit Testing
    •  Connector Repairs
    •  Wiring Repairs


Scan Tool Reference

Control Module References for scan tool information

Circuit/System Verification

Attempt to program the keyless entry transmitter. Refer to Replacing Keys . The transmitter should program.

Circuit/System Testing

  1. Verify that the transmitter is the correct transmitter for the vehicle.
  2. If not correct, replace the transmitter.

  3. Attempt to program the transmitter. Refer to Replacing Keys . The transmitter should program.
  4. If the transmitter does not program, replace the transmitter.

Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.

Control Module References for BCM replacement, setup, and programming

Parts & tools for this job For Vauxhall Astra

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.