Transmission/TransaxleClutch Does Not Disengage
Clutch Does Not Disengage
Cause
|
Actions
|
DEFINITION: When the pedal is pressed to the floor, the shift
lever does not move freely in and out of reverse gear.
|
Damaged clutch disc.
|
Replace the clutch assembly. Refer to
Clutch Pressure and Driven Plate Replacement .
|
Clutch disc hub binding on the input shaft splines.
|
Replace the clutch assembly. Refer to
Clutch Pressure and Driven Plate Replacement .
|
Warped or bent clutch disc.
|
Replace the clutch assembly. Refer to
Clutch Pressure and Driven Plate Replacement .
|
Pedal blocked from full travel.
|
|
1. |
Inspect for obstacles that will prevent the pedal
from going to the floor. |
|
2. |
Clear any obstacles from under the pedal area,
such as floor mats or interior panels. |
|
Too much travel between pedal and hydraulic clutch master
cylinder.
|
|
1. |
Inspect the pedal for worn bushings. |
|
2. |
Replace the pedal bushings if worn. |
|
Hydraulic clutch master cylinder seized or binding.
|
|
1. |
Inspect the master cylinder for the piston being
able to move freely and full range of travel. |
|
Air in the hydraulic clutch system.
|
Bleed the hydraulic clutch system. Refer to
Hydraulic Clutch System Bleeding .
|
Hydraulic clutch actuator cylinder seized or binding
|
|
1. |
Inspect the clutch actuator piston for moving
freely. |
|
Hydraulic clutch master cylinder leaking internally.
|
|
1. |
Inspect for proper pedal reserve. |
| 2.1. |
Let up halfway on pedal. |
| 2.2. |
Apply the pedal a few times. |
| 2.3. |
Inspect to ensure there is still the proper pedal
reserve. |
|
|
| |
|
|
19 Transmission
