vauxhall Workshop Repair Guides

Vauxhall Workshop Service and Repair Manuals

ABOUT US
Servo Motors with Potentiometers > < Control Switch, Outside Rear View Mirror

Omega B

 

 

Control Unit

 

The control unit (1) is installed in the driver's seat console.

All memory system functions are controlled from here.

The control unit, and therefore the entire system, is immediately ready for operation after the driver's door is opened and the ignition is switched on.

After the ignition is switched off or when the driver's door is closed, it remains on standby for approx. 30 sec.

 

 

Object Number: 2390222 Size: DEFAULT

 

 

·    Service

 

To remove the control unit, the driver's seat must be removed and the seat console detached.

 

If the control unit has been replaced, it must be reprogrammed with TECH 1.

 

After programming, read off trouble code

 

Note on trouble code 55

 

Trouble code is only recognized if the following steps have been carried out after programming:

 

1.    Disconnect TECH 1

2.    Ignition off

3.    Close driver's door

4.    Wait 30 sec. until control unit quiescent

5.    Connect TECH 1

6.    Retrieve trouble code

 

 

When one of the position switches is pressed, the seat and the mirrors are adjusted to the memorized positions.

For this, the control unit compares the nominal and actual values.

If there is a difference, the positions are corrected in the following order:

 

I      Seat:

 

-      Seat longitudinal adjustment

-      Seat backrest adjustment

-      Seat height, front

-      Seat height, rear

 

II     Mirrors:

 

-      Rear view mirror, outside, driver's side, vertical

-      Rear view mirror, outside, driver's side, horizontal

-      Rear view mirror, inside, vertical

-      Rear view mirror, inside, horizontal

-      Rear view mirror, outside, co - driver's side, vertical

-      Rear view mirror, outside, co - driver's side, horizontal

 

1     Seat backrest adjustment

2     Seat height adjustment

3     Seat inclination adjustment

4     Seat longitudinal adjustment

5     Switch combination matrix

6     Voltage supply

7     Mirror adjustment

 

 

Object Number: 2390116 Size: DEFAULT

 

 

Note:

 

The stored data is retained even after an interruption of the voltage supply.

 

Servo Motors with Potentiometers > < Control Switch, Outside Rear View Mirror