Protective Foil, Rear Wheel Cutout

Subject:

Protective Foil, Rear Wheel Cutout

 

Vehicles:

Vectra - B

 

Condition:

In production, vehicles intended for delivery to Austria, Switzerland, Norway, Finland and Sweden are fitted with self - adhesive, transparent protective foil in the left and right wheel cutouts.

 

General:

This Technical Information Bulletin describes the operation "Protective Foil, Rear Wheel Cutout, Remove and Install" for use in the event of damage to the protective foil.

Operation:   Protective Foil, Rear Wheel Cutout, Remove and Install   ·     Adhesion of protective foil (1) at temperatures above 18 °C / 64 °F   ·     Heat damaged protective foil with hot air dryer and remove   ·     Clean adhesive surface with washer benzine or silicon remover, perform adhesion on clean, grease - free and dry surface   ·     Remove thick backing paper from protective foil   ·     Position protective foil at lower sill stamped edge (2), align corner of thin backing paper for protective foil to fold edge (3)   ·     Attach protective foil without bubbles using plastic spatula   ·     Remove thin backing paper, disposal according to national regulations

 

 

Parts:

 

 

Designation	Part no	Catalogue no
Protective Foil, Rear Left Wheel Cutout	90 568 952	01 22 767
Protective Foil, Rear Right Wheel Cutout	90 568 953	01 22 768

 

 

Time Allowance:

 

                                               Protective Foil, Rear Wheel Cutout - Replace

                                               TC: 04, 29, 71

 

B 0692 00                               Both sides                                                                                       . 3 hrs

B 0693 00                               Right side                                                                                        . 2 hrs

B 0694 00                               Left side                                                                                          . 2 hrs

 

W 1000 00                              Vehicle from Parking Place to Workplace                            . 2 hrs

                                               and Back

                                               TC: 99

 

The regular warranty procedure should be used for claiming set - up time.