Tie Rod End, Remove and Install (Steering Linkage)

Steering Linkage  

Tie Rod End, Remove and Install  

  Remove, Disconnect   

Remove front wheel.   Measure exposed thread length (2). Remove fastening nut (1). Press tie rod end out of steering knuckle with KM-507-C.   Release lock nut (4) and remove tie rod end from tie rod.     Install, Connect    Attach tie rod end on tie rod and counterhold with nut (4) - tightening torque 60 Nm / 44 lbf. ft. Note pre-measured exposed thread length (2).

  Install, Connect   

Install tie rod end with new fastening nut on steering knuckle - tightening torque 60 Nm / 44.5 lbf. ft.  

Install front wheel - tightening torque 110 Nm / 81 lbf. ft.  

  Adjust   

Check toe-in, and adjust if necessary - see operation "Camber, Caster and Toe-in, Check" in group "E":