- Running gear
- Body
- Engine, mechanics
- Vehicle electrics
- Power transmission
- Heating, ventilation, air conditioning
- Power unit
- Simos injection and ignition system
- Motronic injection and ignition system
- 4-Cyl. injection engine (2 valve, roller rocker finger), Mechanics
- Mono Motronic injection and ignition system
- Diesel injection and glow plug system
- 4-cyl. diesel engine, Mechanics
- 1AV fuel injection and ignition system (2-valve)
- 1AV fuel injection and ignition system (4-valve)
- 4CV fuel injection and ignition system
- 4AV injection and ignition system
- Motronic inj. and ignition system (2-valve, roller rocker finger)
- 4LV injection and ignition system
- 4-Cyl. injection engine (4 valve), Mechanics
- 4-Cyl. injection engine (4-valve, roller rocker arm), Mechanics
- 4-Cyl. injection engine (4 valve, roller rocker finger), Mechanics
- 4-cyl. injection engine (4-valve, roller rocker finger), Mechanics
- 3-cylinder diesel engine
- Direct injection and glow plug system with distributor pump as of 10.99
- Self diagnosis, V.A.G Inspection Service
- Self-diagnosis
- Fault table
- Final control diagnosis
- Measured value blocks
- Safety precautions
- Read measured value block
- Evaluating measured value blocks
- Display group 000 at idling speed (engine warm, coolant temperature not below 80°C)
- Display group 001 at idling speed (engine warm, coolant temperature not below 80°C)
- Evaluation: Display group 1, display zone 2 - quantity injected
- Evaluation: Display group 1, display zone 3 - voltage of modulating piston movement sender
- Display group 002 at idling speed (engine warm, coolant temperature not below 80 °C)
- Evaluation: Display group 2, display zone 2 - accelerator position
- Evaluation: Display group 2, display zone 3 - operating condition
- Display group 003 at idling speed (engine warm, coolant temperature not below 80 °C)
- Display group 004 at idling speed (engine warm, coolant temperature not below 80 °C)
- Evaluation: Display group 4, display zone 2 - commencement of injection (specified)
- Evaluation: Display group 4, display zone 3 - commencement of injection (actual)
- Display group 005
- Display group 006 with ignition switched on
- Evaluation: Display group 6, display zone 2 - brake pedal monitoring
- Evaluation: Display group 6, display zone 3 - cruise control system
- Display group 007 with ignition switched on (engine cold and not running)
- Evaluation: Display group 7, display zone 1 - fuel temperature
- Evaluation: Display group 7, display zone 3 - intake manifold temperature
- Evaluation: Display group 7, display zone 4 - coolant temperature
- Display group 009
- Display group 012
- Display group 013 at idling speed (engine warm, coolant temperature not below 80 °C)
- Evaluation: Display group 13, display zones 1...4 - idling speed smooth running control
- Display group 015
- Display group 016 at idling
- Evaluation: Display group 16, display zone 2 - additional heater
- Evaluation: Display group 16, display zone 3 - actuation of heater elements
- Display group 019 at idle speed
- Evaluation: Display group 19, display zones 1 and 2 - voltage from modulating piston movement sender (start and stop position st
- Display group 000 at full throttle (road test in 3rd gear, coolant temperature not below 80 °C)
- Display group 004 at full throttle (road test in 3rd gear, coolant temperature not below 80 °C)
- Evaluation: Display group 4, display zone 3 - commencement of injection (actual)
- Evaluation: Display group 4, display zone 4 - duty cycle of commencement of injection valve
- Display group 008 at full throttle (road test in 3rd gear, coolant temperature not below 80 °C)
- Evaluation: Display group 8, display zone 2 - quantity injected (driver command)
- Evaluation: Display group 8, display zone 3 - quantity injected limitation via engine speed (torque limitation)
- Evaluation: Display group 8, display zone 4 - quantity injected limitation due to intake air mass (avoidance of smoke)
- Display group 010 at full throttle (road test in 3rd gear, coolant temperature not below 80 °C)
- Evaluation: Display group 10, display zone 4 - accelerator position
- Display group 011 at full throttle (road test in 3rd gear, coolant temperature not below 80 °C)
- Evaluation: Display group 11, display zone 4 - duty cycle of variable intake manifold flap change-over valve
- Fuel preparation system Diesel injection
- Ignition system, glow plug system
- Diesel direct injection and glow plug system up to 09.99
- 4-cylinder injection engine (2-valve), mechanics
- Heating, ventilation, air conditioning system