Single cam cover - r + r and replace gasket

Operation 1016A20 · Cam covers

1.6 TS

Removing

Proceed with the removal - 1016A40 ignition coil cover on cylinder head- r+r.

Proceed with the removal - 5510C14 ignition coil/s - r+r.

1. Disconnect the oil vapour recirculation pipes from the single tappet cover.

1. Undo the bolts (1a) and remove the single tappet cover (1b) complete with gasket.

Refitting

Place the single tappet cover, complete with a new gasket, back in its housing and secure it by tightening the bolts to the recommended torque.

Connect the oil vapour recirculation pipes to the single appet cover.

Proceed with the refitting - 5510C14 ignition coil/s - r+r.

Proceed with the refitting - 1016A40 ignition coil cover on cylinder head- r+r.

2.0 TS

Removing

Proceed with the removal - 1016A40 ignition coil cover on cylinder head- r+r.

Proceed with the removal - 5510C14 ignition coil/s - r+r.

1. Disconnect the oil vapour recirculation pipes from the single tappet cover.

1. Undo the bolts (1a) and remove the single tappet cover (1b) complete with gasket.

Refitting

Place the single tappet cover, complete with a new gasket, back in its housing and secure it by tightening the bolts to the recommended torque.

Connect the oil vapour recirculation pipes to the single appet cover.

Proceed with the refitting - 5510C14 ignition coil/s - r+r.

Proceed with the refitting - 1016A40 ignition coil cover on cylinder head- r+r.

1.9 JTD 8V

Removing

- 1016A10 sound-proofing cover - r + r

1. Disconnect the two oil vapour pipes from the tappet cover.

2. Unscrew the retaining bolts

3. Remove the cam cover.

Refitting

Fit the tappet cover on the cylinder head.

Tighten the bolts fixing the tappet cover to torque.

Connect the oil vapour pipes to the tappet cover.

- 1016A10 sound-proofing cover - r + r