D70 Cruise control not working under any conditions
- Make
- Alfa Romeo
- Model
- 147 Factory Service Manual
- Year
- 2000–2002
- Section
- Engine › D70 Cruise control not working under any conditions
D70 Cruise control not working under any conditions
Under any conditions, the Cruise Control system controls do not work
| Step | Test procedure | Result | Action |
|---|---|---|---|
| 1 | CHECK WITH DIAGNOSTIC EQUIPMENT Connect the diagnostic equipment (Examiner or other instruments) to the diagnostic socket. Check that there are no faults in the engine management control unit | OK | |
| An error is detected in the control unit |
End of diagnosis | ||
| Lack of dialogue with the control unit |
End of diagnosis | ||
| 2 | CHECK CRUISE CONTROL SELECTOR Check that the Cruise Control contacts are working: | OK | |
| Lack of continuity |
End of diagnosis | ||
| 3 | SUPPLY CHECK With the ignition and Cruise Control on, check that there is a voltage signal from the Cruise Control system control to the engine management control unit: Wiring diagram E5060 CRUISE CONTROL | OK | |
| No voltage found |
End of diagnosis | ||
| 4 | CHECK ON CONNECTIONS Check the electrical continuity of the wiring between junction unit, ignition switch, engine management unit and cruise control system control: Wiring diagram E5060 CRUISE CONTROL | OK | |
| Lack of continuity |
End of diagnosis | ||
| 5 | CHECK ON CORRECT OPERATION Check that the fault is no longer present | OK | Incorrect selection of diagnostic procedure |
| Fault persists: control unit faulty |
Incorrect selection of diagnostic procedure |
Parts & tools for this job For 2000 Alfa Romeo 147
- PARTEngine gasket setSearch: Alfa Romeo 147 2000 engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.