Dipped headlamps do not light up as they should
- Make
- Alfa Romeo
- Model
- GT Factory Service Manual
- Year
- 2003–2010
- Section
- Lights › Dipped headlamps do not light up as they should
DIPPED HEADLAMPS DO NOT LIGHT UP AS THEY SHOULD
One or both of the dipped headlamps do not light up the road at the desired distance, but point downwards.
Warning: Presence of high voltage (25 kV) at the gas discharge bulb connector during the first 0.7 secs after the dipped headlamps have been turned on.
Do not switch on the dipped headlamps when the discharge bulb connector is not correctly connected.
Do not disconnect the discharge bulb connector with the dipped headlamps switched on.
Handle the discharge bulb with clean, cloth gloves and never touch the glass bulb with your fingers.
Do not reverse the polarity of the lamp supply lines or else the control unit will be irreversably damaged.
| Results of the tests | ||||
| 0 | PRELIMINARY CHECKS | All OK | Problems met | Operation |
|---|---|---|---|---|
| Check that the dipped headlamps are in the correct position and do not light up irregularly | Continue to Step 1 | Both the headlamps are lowered and not moving | Continue according to the instructions in See table | |
| One headlamp is completely lowered and not moving, the other is working properly | Continue according to the instructions in See table | |||
| One headlamp is not moving in any position, the other is working properly | Continue according to the instructions in See table | |||
| 1 | DEMARCATION CORRECTION CHECK | All OK | Problems met | Operation |
| Check that the static/dynamic correction device for the dipped headlamps demarcation is working | End of diagnosis | There is no dipped headlamps demarcation correction | Continue to Step 2 | |
| 2 | SENSOR FITTING CHECK | All OK | Problems met | Operation |
| Check that the front and rear sensors are correctly fitted | Continue to Step 3 | Mechanical installation of front and/or rear sensor (brackets, connecting rods, etc.) not correct | Refit the sensor correctly | |
| 3 | SENSOR OPERATION CHECK | All OK | Problems met | Operation |
| Check that the front and rear sensors are working properly | Continue to Step 4 | Front sensor damaged | Replace the damaged sensor Op. Op. 5540C42 SENSOR FOR CORRECTING/ALIGNING GAS DISCHARGE LIGHTING UNITS ON FRONT SUSPENSION - R R | |
| Rear sensor damaged | Replace the damaged sensor Op. Op. 5540C46 SENSOR FOR CORRECTING/ALIGNING GAS DISCHARGE LIGHTING UNITS ON REAR SUSPENSION - R R | |||
| 4 | CHECK CONTROL UNIT | All OK | Problems met | Operation |
| Check that the headlamp alignment control unit is working properly | Continue to Step 5 | Control unit fault | Replace control unit Op. | |
| 5 | CHECK ON CORRECT OPERATION | All OK | Problems met | Operation |
| Check that the fault is no longer present | End of diagnosis | The fault persists | Replace the Body Computer Op. | |
Parts & tools for this job For 2003 Alfa Romeo GT
- PARTReplacement bulbsSearch: Alfa Romeo GT 2003 bulbs
- TOOLDigital multimeterSearch: automotive digital multimeter
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.