Workshop Manuals Factory service & repair Aston Martin
01 00 Introduction02 01 Body system03 02 Frame and mounting04 03 Engine05 04 Suspension06 05 Driveline07 06 Brake system08 07 Transmission09 08 Clutch10 09 Exhaust11 10 Fuel12 11 Steering13 12 Climate control14 13 Information, gauge and warning15 14 Power supply16 15 Vehicle entertainment17 16 Vacuum distribution18 17 Lighting19 18 Electric distribution and electronic control20 19 Electronic features21 20 Appendix and glossary
Aston Martin DB9 Factory Workshop Manual (Issue 2, 2005)05 · 04 Suspension
05 · Steering & suspension

Tyre Damage

Make
Aston Martin
Model
DB9 Factory Workshop Manual
Year
Issue 2, 2005
Section
Road Wheels and Tyres › Tyre Damage
04 SuspensionTyre Damage
SymptomPossible Source(s):Action(s)
Vehicle vibrationsTyres and wheels mismatchedInstall correct tyre and wheel combination.
Inflation pressure too high or too lowCorrect pressure to specification
Uneven tyre wearRefer to Diagnosis and Testing.
Out-of-balance wheel, tyre, wheel hub or disc assemblyDetermine the out-of-balance component and balance or install a new part.
Damaged or distorted wheel from road impact hazard or incorrect handlingInstall a new wheel.
Excessive radial runoutInstall a new wheel or tyre. Check for incorrect wheel and tyre specifications.
Excessive lateral runoutInstall a new wheel or tyre.
Incorrectly seated tyreRemount the tyre.
Loose wheel mountings - damaged wheel studs, wheel nuts, worn or broken wheel hub face or foreign material on mounting facesTighten or install new parts. Clean mounting surfaces.
Defective wheel bearingsInstall a new bearing set.
Brake disc imbalance
Water in tyresRemove water.
Loose engine or transmission mountsInstall new mount nuts / install new mounts.
Incorrect front end alignmentAlign front end.
Loose or worn driveline or suspension partsRepair or install new parts.
Excessive driveshaft runout or imbalanceInstall a new driveshaft.
Worn or damaged flexible drive jointInstall a new driveshaft.
Damaged wheel hub stud threadsSliding wheel across the wheel studs during installation. Loose wheel nutsInstall new wheel studs.
Broken wheel studsLoose or over tightened wheel nutsInstall new wheel studs.
Corrosion and contamination streaks from the wheel hub wheel stud holesLoose wheel nutsCheck complete assembly. Install new parts.
Damaged wheel nutsLoose wheel assemblyInstall new wheel nuts.
Over-tightened wheel nutsInstall new wheel nuts.
Frozen wheel nutsCorrosion or gallingIf corrosion is light, wire brush away corrosion. If corrosion is excessive install new wheel studs and wheel nuts.

Tyre Damage

SymptomDescription
Age DeteriorationCracking and crazing of the tread and sidewall rubber, sometimes accompanied by carcass deformation. An indication that the tyres have been in service for a very long time.
Neglected CutDamage through accidental cuts or penetrations will extend in use due to continued flexing and / or ingress of moisture and road matter.
Impact FractureResultant damage from impact fractures is not always visible externally and, therefore, as a safety precaution the tyre should be removed and examined.
Casing fracture caused by severe localized impact through driving over kerbs, hitting potholes and / or objects in the road.
A double fracture caused by crushing the side wall of the tyre between an object and the rim flange.
In both instances, such damage can lead to sudden and dangerous tyre deflation some time after the impact occurred.

Parts & tools for this job For 2005 Aston Martin DB9

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.