Waste gate supercharging pressure adjustment solenoid valve - r.r.
- Make
- Fiat
- Model
- Bravo Factory Service Manual
- Year
- 2007–2014
- Section
- Engine supercharging system › Waste gate supercharging pressure adjustment solenoid valve - r.r.
‹ Prev Pressurized air recirculation pipe for waste gate valve - r.r.Next › Accelerator pedal checks
EngineWaste gate supercharging pressure adjustment solenoid valve - r.r.
WASTE GATE SUPERCHARGING PRESSURE ADJUSTMENT SOLENOID VALVE - R.R.
Removing
1. Disconnect the electrical connection for the Waste Gate solenoid.
| Description | Connector | |
|---|---|---|
| 1 | Waste gate solenoid | See L037 WASTE GATE SOLENOID VALVE |
2. Compress clip (2a) at point shown in the figure and remove Waste Gate solenoid (2b) form mounting bracket.
Mark the position of the air pipes.
1. Loosen the bands and disconnect the air pipes from the Waste Gate solenoid.
2. Remove Waste Gate solenoid.
Refitting
- Connect the air pipes to the Waste Gate solenoid and close the bands.
- Refit the Waste Gate solenoid in its housing until the retaining clip has attached.
- Connect the electrical connection for the Waste Gate solenoid.
‹ Prev Pressurized air recirculation pipe for waste gate valve - r.r.Next › Accelerator pedal checks
Parts & tools for this job For 2007 Fiat Bravo
- PARTEngine gasket setSearch: Fiat Bravo 2007 engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.