Workshop Manuals Factory service & repair Fiat
Fiat Bravo/Brava (182) Factory Service Manual (1995-2001)08 · 50 Auxiliary units
08 · General

Manual heating/ventilation system

Make
Fiat
Model
Bravo /Brava (182) Factory Service Manual
Year
1995–2001
Section
Heating/ventilation system › Manual heating/ventilation system
50 Auxiliary unitsManual heating/ventilation system · page 1 of 2

Manual heating/ventilation system

Diagram showing the location of the condenser and air shroud in the engine compartment

CONDENSER

Removing

Before removing, arrange the vehicle on a lift, then drain the air conditioning system and the cooling system.

Diagram showing the connection point between the compressor and the condenser line
  1. Unscrew the bolts indicated and remove the air shroud.
  2. Unscrew the screw indicated and release line connecting compressor to condenser.
  3. Unscrew the screw indicated and remove line connecting condenser to dehydrating filter. Seal ends of pipes disconnected from condenser using sealing plugs to prevent moisture entering the system.
  4. Unscrew bolts indicated in figure which retain engine cooling radiator to body.
Diagram showing the connection point between the condenser and the dehydrating filter

Parts & tools for this job For 1995 Fiat Bravo

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.