INTERMEDIATE DRIVESHAFT - R R

Operation 2710A31 · DRIVESHAFTS AND JOINTS

1.9 JTD 8v, 1.9 JTD 16v, 2.4 JTD 20v

Removing

- Position the vehicle on a lift.

Op. 4450B04 RIGHT FRONT WHEEL - R.R

Op. 2710A14 RIGHT HAND DRIVE SHAFT WITH JOINTS - R+R

- Position the front driveshaft in a vice fitted with protective jaws.

Two mechanics are needed for this operation.

- Remove the bands securing the protective boot using a suitable tool.

- Turn the boot upsidedown to uncover the three-lobe joint.

- Using a suitable drift and hammer, disconnect the intermediate driveshaft from the front driveshaft.

Refitting

- Fill the joint and the boot with the specified grease.

- Using a suitable drift, fit the intermediate driveshaft on the front driveshaft.

- Place the boot back in its housing.

- Fit two new bands securing the boot using a suitable tool.

- Remove the front driveshaft from the vice fitted with protective jaws.

Op. 2710A14 RIGHT HAND DRIVE SHAFT WITH JOINTS - R+R

Op. 4450B04 RIGHT FRONT WHEEL - R.R

- Remove the vehicle from the lift.

2.2

Removing

Op. 2710A10 DRIVESHAFT WITH JOINTS (ONE), L/H OR R/H - R + R

(right side).

1. Unscrew bolts (1a) and remove the intermediate drive shaft (1b).

Refitting

1. Place the intermediate drive shaft (1a) in its housing and secure it tightening the bolts (1b) to the recommended torque.

Op. 2710A10 DRIVESHAFT WITH JOINTS (ONE), L/H OR R/H - R + R

(right side).