Workshop Manuals Factory service & repair Fiat
01 General information02 Specifications03 Manufacturing data and tolerances04 Tightening torques05 Fluids and lubricants06 Maintenance07 Diagnostic checks08 Engine09 Clutch10 Gearbox and differential11 Axles and driveshafts12 Brakes13 Steering14 Suspension and wheels15 Heating, air conditioning and auxiliary units16 Electrical equipment17 Body fittings18 Body panels and frame19 Wiring diagrams and electrical functions20 Wiring harnesses21 Connectors and pin-outs22 Fault diagnosis23 Special tools
Fiat Doblò Factory Service Manual (2000-2010)08 · Engine
08 · Engine

Timing CHAIN TENSIONER PLATE - R.R.

Make
Fiat
Model
Doblò Factory Service Manual
Year
2000–2010
Section
Timing system › Timing CHAIN TENSIONER PLATE - R.R.
EngineTiming CHAIN TENSIONER PLATE - R.R.

Timing CHAIN TENSIONER PLATE - R.R.

Operation 1032C40 · Timing system tensioners

Removing

Position the car on the ramp.

Make sure that the ignition key is in the OFF position; then disconnect the negative battery terminal.

NameConnector
BatteryA1B

Carry out - 7055B54 under-engine guard - r r.

Drain the air conditioner coolant circuit - 0010T84 coolant for air conditioning system dehydrate and recharge.

Carry out - 4450B04 right front wheel r r.

Carry out.

Carry out - 1092C10 power steering and/or self-levelling suspension pump drive belt - r + r.

Carry out - 1092G10 single engine belt r r.

Carry out - 1092A10 Crankshaft services PULLEY - R.R..

Carry out - 2110A60 manual gearbox/engine coupling bracket - r+r.

Carry out - 1020A20 crank case oil sump - r + r clean seals for sealant application.

Carry out - 1020B10 cover of timing system with chain drive - r + r replace oil seal and gasket.

Carry out - 1032A12 CHAIN AND GEARS for timing system - R.R. for timing or Replacement..

PROCEED AS FOLLOWS FOR THE MOBILE PAD

1. Withdraw pin (1a)a nd remove the mobile pad of timing chain (1b).

Timing CHAIN TENSIONER PLATE - R.R.

PROCEED AS FOLLOWS FOR THE FIXED PAD

1. Undo the bolts (1a) and remove the timing belt fixed pad (1b).

Timing CHAIN TENSIONER PLATE - R.R.

Refitting

PROCEED AS FOLLOWS FOR THE FIXED PAD:

Refit the fixed timing belt pad in its seat and secure with bolts.

PROCEED AS FOLLOWS FOR THE MOBILE PAD:

Refit the mobile timing belt pad in its seat and secure with bolts.

Carry out - 1032A12 CHAIN AND GEARS for timing system - R.R. for timing or Replacement..

Carry out - 1020B10 cover of timing system with chain drive - r + r replace oil seal and gasket.

Carry out - 1020A20 crank case oil sump - r + r clean seals for sealant application.

Carry out - 2110A60 manual gearbox/engine coupling bracket - r+r.

Carry out - 1092A10 Crankshaft services PULLEY - R.R..

Carry out - 1092G10 single engine belt r r.

Carry out - 1092C10 power steering and/or self-levelling suspension pump drive belt - r + r.

Carry out.

Carry out - 4450B04 right front wheel r r.

Refill the engine oil lubrication system - 0010T11 engine oil check level and top up.

Refill the engine cooling system with coolant - 0010T20 coolant change.

Fill the air conditioner coolant circuit - 0010T84 coolant for air conditioning system dehydrate and recharge.

Carry out - 7055B54 under-engine guard - r r.

Connect the battery negative terminal.

NameConnector
BatteryA1B

Remove the car from the ramps.

Parts & tools for this job For 2000 Fiat Doblò

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.