LAMBDA PROBE R R

Operation 1080B90 · EXHAUST EMISSION CONTROL SYSTEM

2.0 16V

Removing

- Position the vehicle on the lift.

- Disconnect the negative battery terminal.

- Raise the vehicle.

1. Disconnect the electrical connection for the Lambda sensor.

1. Act on the plastic springs fastening the electrical cable to the exhaust pipe heat shield.

2. Undo the Lambda sensor and remove it.

Refitting

- Position the Lambda sensor and tighten it.

- Position the electrical cable and close the plastic fastening bands.

- Connect the electrical connection for the Lambda sensor.

- Lower the vehicle.

- Connect the negative battery terminal.