TANK FUEL VAPOUR SEPARATOR - R + R

Operation 1080E10 · EVAPORATION CONTROL SYSTEM

2.0 16V

Removing

See in Op. 1048A14

1. Release the retaining springs (1a) and move the pipe (1b) aside.

2. Disconnect the rapid connectors at the bottom of the separator.

3. Undo the bolt fixing the bracket (3a) and remove the fuel vapour separator from the lower section (3b).

Refitting

- Place the fuel vapour separator in position.

- Tighten the bolt fixing the bracket.

- Connect the rapid connectors at the bottom of the fuel vapour separator.

- Fit the pipe and restore the band removed previously.

See in Op. 1048A14