CNG CYLINDER RECHARGE VALVE - R R

Operation 1042A34 · METHANE GAS CANNISTER AND TUBES FOR RE-CHARGING

2.0 16V

Removing

Position the vehicle on the lift.

Proceed with draining the high pressure circuit following the instructions described in the procedure below:

Op. 1042A02 C.N.G. - FUEL SYSTEM SAFETY CHECK

Op. 1042A30 CNG CYLINDER RECHARGE VALVE COCK - R R

1. Undo the retaining bolts.

2. Remove the load carrying compartment side trim cover.

1. Remove the retaining buttons (1b) using the tool (1a).

2. Remove the side load carrying compartment trim.

1. Undo the bands (1a) and release the safety pipe (1b).

2. Undo the connector and disconnect the canister repressurizing pipe.

3. Undo the ring nut (3a) and remove the plastic protective cover (3b).

1. Remove the seal.

1. Remove the canister repressurizing valve.

Refitting

Place the canister repressurizing valve in position.

Fit the seal in the housing.

Fit the protective plastic cover and tighten the ring nut.

Connect the canister repressurizing pipe and tighten the connector to the recommended torque.

Restore the position of the safety pipe and secure it using the special bands.

Place the load carrying compartment side trim in position and secure it using the special fixing buttons.

Place the load carrying compartment side trim cover in position and tighten the fixing bolts.

Op. 1042A30 CNG CYLINDER RECHARGE VALVE COCK - R R

Remove the vehicle from the lift.