BONNET WIND NOISE LOCALISATION

Check 7025OA

Tape the various areas illustrated in the diagram using bodywork gummed paper.

Carry out a road test letting the vehicle gradually reach the speeds where the noise starts: if the wind noise persists, check that the plugs are present and that the rubber cable ducts in the fire-proof partition are correctly fitted.

Remove the gummed paper from area A and repeat the road test: if the wind noise persists, check the buffers where the bonnet and the wings match at the rear.

Remove the gummed paper from area B and repeat the road test: if the wind noise persists, check the condition of the front weatherstrip and make sure it is correctly fitted (it should adhere perfectly to the crossmember when the bonnet is closed).

Op. 7025A62 BONNET LID WEATHERSTRIP - R+R