BADGE ON TAILGATE - R.R

Operation 7055A83 · EXTERIOR MOULDINGS

Removing

1. Using a plastic blade, remove the badge (1a) unsticking the double-sided tape (1b) around the perimeter and releasing the centering pins (1c).

Refitting

- Check that the badge is not damaged.

1. Clean the housing for the badge, removing the residual adhesive and degrease with heptane.

2. Remove the protective film (2a) for the double-sided tape and place the badge (2b) in position, engage the retainers (2c) and fit it.

This operation should be carried out at a temperature above 20°C.