Workshop Manuals Factory service & repair Fiat
01 General information02 Specifications03 Manufacturing data and tolerances04 Tightening torques05 Fluids and lubricants06 Maintenance07 Diagnostic checks08 Engine09 Clutch10 Gearbox and differential11 Transmission (4x4)12 Axles and driveshafts13 Brakes14 Steering15 Suspension and wheels16 Heating, air conditioning and auxiliary units17 Electrical equipment18 Body fittings19 Body panels and frame20 Wiring diagrams and electrical functions21 Wiring harnesses22 Connectors and pin-outs23 Fault diagnosis24 Special tools
Fiat Panda Factory Service Manual (2003-2012)23 · Fault diagnosis
23 · Diagnostics

Longitudinal acceleration sensor error

Make
Fiat
Model
Panda Factory Service Manual
Year
2003–2012
Section
Examiner › Longitudinal acceleration sensor error
Fault diagnosisLongitudinal acceleration sensor error

LONGITUDINAL ACCELERATION SENSOR ERROR

The diagnostic equipment signals the following error: "C1335 - Longitudinal acceleration sensor"

This error is signalled if the sensor output voltage is below 0.3 V or above 4.7 V or if the yaw sensor supply voltage is more than 5.3 V or less than 4.7 V or if the value sent by the sensor is not plausible. This means that there is an open circuit or short circuit (positive or earth) for the sensor or the wiring, that the sensor is mechanically damaged or that the reading circuit is damaged.

1ELECTRICAL CHECKSAll OKProblems encounteredOperation

Check that the longitudinal acceleration sensor supply voltage is between 4.7 and 5.3 V

See E7023 ESP

Vedere Prova 3350ED VERIFICA SENSORE DI ACCELERAZIONE LONGITUDINALE

Check that the longitudinal acceleration sensor output voltage (longitudinal acceleration sensor) is in the range between 0.3 and 4.7 V

Move on to Step 3 1Voltage not correct at accelerometerMove on to Step 2 1
2ELECTRICAL CONNECTION CHECKAll OKProblems encounteredOperation
Check that the electrical connections between the acceleration sensor and the ABS control unit are correctMove on to Step 3 1
  • Wiring faulty
  • Sensor not correctly fastened
  • Renew the wiring and move on to Step 3
  • Restore the correct fastening for the sensor and move on to Step 3
3CHECK ON CORRECT OPERATIONAll OKProblems encounteredOperation

Delete the errors using the diagnostic equipment.

Carry out a road test

Vedere Prova 3350EA VERIFICA DI INTERVENTO SISTEMA ESP

to ensure that the control unit checks whether there are any errors still present.

Return to the workshop and check that the fault is no longer present using the diagnostic equipment

End of diagnosisThe fault persistsMove on to Step 1

Parts & tools for this job For 2003 Fiat Panda

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.