Non-calibrated longitudinal acceleration sensor error
- Make
- Fiat
- Model
- Panda Factory Service Manual
- Year
- 2003–2012
- Section
- Examiner › Non-calibrated longitudinal acceleration sensor error
Fault diagnosisNon-calibrated longitudinal acceleration sensor error
NON-CALIBRATED LONGITUDINAL ACCELERATION SENSOR ERROR
The diagnostic equipment signals the following error: "C1435 - Longitudinal acceleration sensor not calibrated"
This error is signalled if the acceleration sensor has not been calibrated
| 1 | LONGITUDINAL ACCELERATION SENSOR CALIBRATION | All OK | Problems encountered | Operation |
|---|---|---|---|---|
| Connect the Examiner, enter diagnostic mode and select the longitudinal acceleration sensor. Calibrate the sensor by following the procedure described. | Move on to Step 2 1 | The sensor cannot be calibrated | Replace the sensor Op. 3350E31 SENSOR FOR LONGITUDINAL ACCELERATION (HILL HOLDER) - R.R. Move on to Step 2 1 | |
| 2 | CHECK ON CORRECT OPERATION | All OK | Problems encountered | Operation |
Delete the errors using the diagnostic equipment. Carry out a road test See Test 3350EA ESP SYSTEM ACTUATION CHECK to ensure that the control unit checks whether there are any errors still present. Return to the workshop and check that the fault is no longer present using the diagnostic equipment | End of diagnosis | The fault persists | Move on to Step 1 1 |
Parts & tools for this job For 2003 Fiat Panda
- TOOLOBD2 scannerSearch: OBD2 scanner
- TOOLDigital multimeterSearch: automotive digital multimeter
- TOOLBack-probe test leadsSearch: back probe test leads
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.