Solenoid valve overheating error
- Make
- Fiat
- Model
- Panda Factory Service Manual
- Year
- 2003–2012
- Section
- Examiner › Solenoid valve overheating error
‹ Prev Impossible to enter fault diagnosis at ABS control unitNext › Non-calibrated longitudinal acceleration sensor error
Fault diagnosisSolenoid valve overheating error
SOLENOID VALVE OVERHEATING ERROR
The diagnostic equipment signals the following error "C1098 - Solenoid valves overheating"
This error is signalled if they are activated for too long in order to preserve them.
| 1 | SOLENOID VALVE COOLING | All OK | Problems encountered | Operation |
|---|---|---|---|---|
Avoid activating the solenoids with the diagnostic tester for a few minutes. Blow on the electrohydraulic control unit with compressed air | Move on to Step 2 1 | |||
| 2 | CHECK ON CORRECT OPERATION | All OK | Problems encountered | Operation |
Delete the errors using the diagnostic equipment. Carry out a road test See Test 3340OA A.B.S. SYSTEM ACTUATION CHECK to ensure that the control unit checks whether there are any errors still present. Return to the workshop and check that the fault is no longer present using the diagnostic equipment | End of diagnosis |
‹ Prev Impossible to enter fault diagnosis at ABS control unitNext › Non-calibrated longitudinal acceleration sensor error
Parts & tools for this job For 2003 Fiat Panda
- PARTEngine gasket setSearch: Fiat Panda 2003 engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.