Workshop Manuals Factory service & repair Fiat
Fiat Punto (176) Factory Service Manual (1993-1999)10 · 70 Bodywork
10 · Body & interior

Cutting rear cross member

Make
Fiat
Model
Punto (176) Factory Service Manual
Year
1993–1999
Section
Replacing body panels › Cutting rear cross member
70 BodyworkCutting rear cross member
Technician using a power saw to cut the outer part of the cross member inside the vehicle's rear compartment
Technician using a hammer and chisel at specific points on the cross member
Rear view of the vehicle showing the open tailgate and internal structure near the spare wheel housing

Cutting rear cross member

Proceed as described below:

  1. Using the power saw cut the outer part of the cross member.
  2. Use the hammer and chisel at the points shown in order to allow the introduction of the power saw blade.
  3. Using the power saw cut the cross member cover near the spare wheel housing.
  4. Complete the cutting of the cross member near the rear wing.
Technician using a power saw to cut the cross member cover near the spare wheel housing
Technician completing the cutting of the cross member near the rear wing

Parts & tools for this job For 1993 Fiat Punto

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.