10 EngineRefitting · page 2 of 2
(Cont. Op. 1016A22)
- Insert the coolant pipe on the throttle case.
- Restore the electrical connection to the ignition coils
| Name | Connector |
|---|
| - | Ignition coil N° 1 (cyl. 1-4) | A30 |
| - | Ignition coil N° 2 (cyl. 2-3) | A30 |
- Connect the idle regulation actuator electrical connection I
| Name | Connector |
|---|
| - | Idle actuator | N74 |
- Connect the throttle position sensor electrical connection
| Name | Connector |
|---|
| - | Throttle position connector | K56 |
- Connect the intake air temperature sensor electrical connection
| Name | Connector |
|---|
| - | Air temperature sensor | K42 |
- Connect the single injector (SPI) electrical connection
| Name | Connector |
|---|
| - | Single-injector (SPI) | N71 |
- Assemble the air filter cover with pipes and throttle case air conveyor.
- Insert the oil vapours recovery pipe on the throttle case.
- Insert the oil vapours recovery pipe on the tappet cover.
- Tighten the throttle case air conveyor screws.
- Hook the air filter cover clasps.
- Rill the engine cooling system with coolant
| Type | Component | Name | Qty |
|---|
| - | Coolant (l) | ENGINE COOLING SYSTEM | Paraflu11 | 4.8 |
- Screw on the engine cooling circuit breather plug .
- Screw on the engine coolant tank cap.
- Connect the negative (-) battery terminal
- Remove car body protection covers.
- Close the engine compartment.
- Remove the vehicle from the hoist.
02 Engine
