10 Engine Refitting · page 2 of 2
(Cont. Op. 1016C10)
Place the cylinder head on the crank case.
Lubricate the screws and washers and let them drain for at least 30 minutes.
Screw the cylinder head screws to the correct torque following the sequence indicated in the figure
Attachment Component Ø Value (daNm) 1 Screw CYLINDER HEAD M9 2.0
Further tighten to torque the cylinder head screws following the sequence indicated in the figure
Attachment Component Ø Value (daNm) 1 Screw CYLINDER HEAD M9 3.0
In two stages further tighten the cylinder head screws, with an overall angular rotation of 180° (90° + 90°) with the tool
Measure Value - Angular rotation 90°+90°
Name Code 2 Goniometer 1.860.942.000
The cylinder head screws used with the ASTADUR gasket are the type with locking to yield point. These screws are to be replaced after 4 lockings.
Insert the rocker control rod.
Reposition the rocker carrier axle with rocker supports and hydraulic tappets.
Tighten the rocker carrier axle screws to correct torque
Attachment Component Ø Value (daNm) - Nut ROCKER CARRIER AXLE SUPPORT M10 3.9
Raise the car.
Tighten the nuts securing the exhaust pipe to the manifold to the correct torque
Attachment Component Ø Value (daNm) - Nut EXHAUST MANIFOLD M8 3.2
Lower the car.
Insert the hot air intake sleeve on the exhaust manifold.
Tighten the engine oil rod pipe screw.
Electrically connect the engine temperature sensor
Name Connector - Engine temperature sensor K45
Connect the earth cable on the engine.
Name Connector - Earth on engine C40
Connect the engine coolant temperature sender electrical connection
Name Connector - Engine coolant temperature sender K35
Insert the coolant sleeve on the thermostat.
Insert the coolant pipe on the thermostat.
Complete with Op. 1016A22 TAPPET COVER with supply duct - R+R. and Replace gasket.Complete with Op. 1068A10 ACCELERATOR PEDAL CONTROL - Check, adjustment if necessary and lubrication.Connect the negative (-) battery terminal
Remove car body protection covers.
Close the engine compartment.
Remove the vehicle from the hoist.
02 Engine
