10 EngineRefitting · page 2 of 4
( Cont. Op. 1004B12)
- Connect the earth cable on the engine.
| Name | Connector |
|---|
| Earth on engine | C40 |
- Connect the ignition coils electrical connections
| Name | Connector |
|---|
| Ignition coil N° 1 (Cyl. 1-4) | A30 |
| Ignition coil N° 2 (Cyl. 2-3) | A30 |
- Connect the idle regulation actuator electrical connection.
| Name | Connector |
|---|
| Idle actuator | N74 |
- Connect the intake air temperature sensor electrical connection
| Name | Connector |
|---|
| Air temperature sensor | K42 |
- Connect the throttle position sensor electrical connection
| Name | Connector |
|---|
| Throttle position sensor | K56 |
- Electrically connect the single-injector (SPI)
| Name | Connector |
|---|
| single-injector (SPI) | N71 |
- Electrically connect the engine coolant temperature sender
| Name | Connector |
|---|
| Engine coolant temperature sender | K35 |
- Connect the electrical connection of the engine oil pressure switch
| Name | Connector |
|---|
| Engine oil pressure switch | K30 |
- Connect the electrical connection of the engine temperature sensor
| Name | Connector |
|---|
| Engine temperature sensor | K45 |
- Connect the starter motor electrical connection
| Name | Connector |
|---|
| Starter motor | A20 |
- Electrically connect the alternator
| Name | Connector |
|---|
| Alternator | A10 |
- Connect the electrical connection to the rev sensor
| Name | Connector |
|---|
| Rev sensor | K46 |
- Insert the vacuum intake pipe of the fuel vapours on-off solenoid valve on the throttle case.
- Insert the absolute pressure sensor pipe on the throttle case.
- Electrically connect the reversing lights switch
| Name | Connector |
|---|
| Reversing lights switch | I20 |
- Connect the alternator and starter motor wiring terminals to the battery (+) terminal
- Connect the battery earth to the gearbox
| Name | Connector |
|---|
| Battery earth on gearbox | C1 |
- Connect the clutch release control hose to the thrust bearing control levers.
- Complete with Op. 1820A14 CLUTCH PEDAL - Stroke adjustment.
- Connect the sleeve to the water pump rigid inlet pipe.
- Connect the lower sleeve to the radiator.
- Connect the upper sleeve to the radiator.
- Join the wheel pillars to the constant velocity joints.
(Cont.)
02 Engine
