10 Engine Refitting · page 3 of 4
( Cont. Op. 1004B12)
Join the wheel pillars to the dampers and tighten the nuts to the correct torque
Fastening Component Ø Value (daNm) - Nut FRONT DAMPER M12 9.1
Note: When tightening the front hub pillar screws, push the pillars upwards to eliminate any mounting clearances.
Join the side connecting rod pins of the articulating heads of the steering wheel to the pillars and tighten the nuts to correct torque
Fastening Component Ø Value (daNm) - Nut ARTICULATING HEAD SIDE CONN.ROD STEERING WHEEL M10 3.4
Tighten the constant velocity joint fastening nuts to the wheel hubs, to the correct torque
Fastening Component Ø Value (daNm) 1 Nut WHEEL HUB M22 24.0
Note: Keep the brake pedal pressed while tightening the nuts.
Use the tool to squeeze the wheel hub nuts
Name Code 1 Tool 1.875.063.000
Complete with Op. 1076B50 Exhaust pipe mounting to engine/manifold - R+R.
Electrically connect the lambda sensor
Name Connector - Lambda sensor K40
Connect the solenoid that powers the conditioner compressor
Name Connector - Solenoid to power conditioner compressor L20
Join the mileage counter transmission to the gearbox.
Install the ignition coils protection.
Install the air cleaner thermostatic device with dashpot.
Insert the hot air intake sleeve on the exhaust manifold.
Complete with Op. 1048A10 COMPLETE AIR CLEANER - R+R.
Fit the engine compartment protection.
Fill the engine cooling system with coolant
Type Component Name Qty - Coolant (I) ENGINE COOLING SYSTEM Paraflu11 4.0
(Cont.)
02 Engine
