Clutch release controls

CLUTCH RELEASE CONTROLS

(Cont.d Op. 1820A20)

• Raise the car.
• Slacken the nuts (1a) of the clutch release control hose (1b) and withdraw it.

Reassembly

• Insert the clutch release control hose and fasten it with the corresponding nuts.
• Lower the vehicle.
• Connect the end of the clutch release control hose to the clutch pedal.
• Connect the clutch release control hose to the thrust bearing control levers.
• Complete with Op. 1820A14 CLUTCH PEDAL - Stroke adjustment.
• Connect the battery (-) terminal

• Remove the protective coverings from the car body.
• Close the engine compartment.
• Remove the car from the car lift.

1820A24 - THRUST BEARING CONTROL LINKAGE - R+R.

Removal

• Follow Op. 4450B12 Front (two) WHEELS - R+R.
• Remove the additional left wheelhouse (refer to Op. 7055B42 SUPPLEMENTARY WHEELHOUSE (one)) - R+R.).
• Follow Op. 1048A28 Vacuum air circuit RESOUNDING DEVICE - R+R.
• Follow Op. 2110A10 MANUAL GEARBOX with differential- R+R.
• Follow Op. 1820A26 Thrust bearing control LINKAGE - R+R. with gearbox removed.

Reassembly

• Complete with Op. 1820A26 Thrust bearing control LINKAGE - R+R. with gearbox removed.
• Complete with Op. 2110A10 MANUAL GEARBOX with differential - R+R.
• Complete with Op. 1048A28 Vacuum air circuit RESOUNDING DEVICE - R+R.
• Assemble the additional left wheelhouse (refer to Op. 7055B42 SUPPLEMENTARY WHEELHOUSE (one)) - R+R.).
• Complete with Op. 4450B12 Front WHEELS (two) - R.R.

1820A26 - THRUST BEARING CONTROL LINKAGE - R+R. WITH GEARBOX REMOVED

Removal

1. Remove the clutch thrust bearing.

1. Remove the retainer ring of the external clutch thrust bearing linkage.

(Cont.d)