Reassembly

(Cont.d Op. 2110A12)

1. Set a hydraulic jack on the support and operate it until the gearbox is supported.

1. Slacken the screws of the support flexible block on the gearbox side.

1. Slacken the support flexible block screws.

• Move the gearbox to withdraw the shaft from the clutch driven plate.
• Lower the hydraulic jack and withdraw the gearbox from the engine compartment.

1. Move the hydraulic jack with the gearbox.

Reassembly

• Re-position the hydraulic jack with the gearbox under the raised car.
• Raise the gearbox with the hydraulic jack and position it in the engine compartment.
• Insert the gearbox shaft in the clutch driven plate.

Note: To aid centering the pins on the engine and the gearbox shaft with the driven plate, gently sway the gearbox/differential unit.

• Tighten the screws of the rear support flexible block to the specified torque

(Cont.d)