Reassembly (page 2 of 4)

(Cont.d Op. 2110A12)

• Tighten the screws of the gearbox side flexible block to the specified torque

• Lower the hydraulic jack and remove it from under the car.
• Slacken the fastening screws and remove the tools from the gearbox.

• Tighten the nut fastening the rear stiff support to the differential to the specified torque

• Assemble the gearbox guard and fasten it with the corresponding screws to the specified torque

If the oil was drained during gearbox removal, fill with oil.

• Clean the gearbox oil drain plug and tighten it to the specified torque

1. Slacken the gearbox oil filler cap.

• Fill the gearbox with oil through the filler hole

• Check that the level reaches the lower edge of the filler hole.
• Clean the filler cap and tighten it to the specified torque

• Connect the wheel uprights to the joints.
• Connect the wheel uprights to the dampers and tighten the nuts to the specified torque

Note: When tightening wheel the upright nuts, push the uprights upwards to eliminate any play of the fastenings.

• Connect the track rod knuckle pins to the wheel uprights and tighten the nuts to the specified torque

(Cont.d)