Reassembly (page 3 of 4)

Cont.d Op. 2110A12)

1. Tighten the nuts fastening the joints to the wheel hubs to the specified torque

Note: Keep the brake pedal pressed when tightening the nuts.

1. Use the tool to squeeze the wheel hub nuts

• Complete with Op. 1076B50 Exhaust PIPE attachment to engine/manifold- R+R.
• Connect the gearbox side mileage recorder cable.
• Complete with Op. 7055B42 SUPPLEMENTARY WHEEL ARCH (one) - R+R.
• Complete with Op. 4450B12 Front WHEELS (two) - R.R.
• Lower the vehicle.
• Disconnect the tie-rod of the engine support crossmember.
• Remove the engine support crossmember complete with rest blocks

• Tighten the screws and the nut fastening the gearbox to the engine to the specified torque

• Insert the ends of the gear engagement flexible pipes.
• Insert the clamps on the gear engagement flexible pipe sheaths.
• Re-position the starter motor (refer to Op. 5520B10 STARTER MOTOR - R+R.) and tighten the fastening screws to the specified torque

• Connect the electrical connection of the reversing light switch

• Connect the clutch release control hose to the clutch thrust bearing control linkage.
• Complete with Op. 1820A14 PEDALE FRIZIONE - Stroke adjustment.
• Assemble the air filter support and fasten it with the corresponding screws.

(Cont.d)