33 Braking system Refitting
(Cont. Op. 3340A12)
Remove the ABS unit.
Refitting
Reposition the ABS unit in its seat and fasten it with the nuts.
Connect the electrical connection to the lower part of the ABS unit.
Name Connector
- ABS unit M50
Fasten the brake pipes to the ABS unit with the tool and torque.
Description Code
- Wrench 1.856.132.000
Coupling Component Ø Value (daNm)
FITTING ABS UNIT PIPES M10 1.1
Fit the fastening clip on the pipes.
Complete with Op. 3330A10 BRAKE FLUID - Checking level and topping-up (if required).Complete with Op. 3330A14 BRAKE HYDRAULIC CIRCUIT - Air relief.Fasten the cap on the brake fluid reservoir.
Connect the electrical connections to the brake fluid reservoir.
Name Connector
- Brake fluid level switch K25
Connect the negative (-)battery terminal.
Name Connector
- Battery A1
Remove the body protection cover.
Close the engine compartment.
3340A30 - FRONT WHEEL REVOLUTION SENSOR (ONE), LH OR RH, R.R.
Removal
Position the vehicle on a shop jack.
Open the engine compartment.
Assemble the body protection covers.
Disconnect the (-) battery terminal.
Name Connector
- Battery A1
Disconnect the front right-hand (1a) or left-hand (1b) wheel revolution sensor electrical connection.
(Continued)
06 General
